The Geissele Super Semi-Automatic (G2S) trigger is renowned among firearms enthusiasts for its crisp break, short reset, and overall exceptional performance. However, installation isn't always straightforward. This guide provides a detailed walkthrough, ensuring a smooth and successful installation process. Disclaimer: Always prioritize safety. Improper handling of firearms can lead to serious injury or death. Consult a qualified gunsmith if you are uncomfortable performing this installation.
Tools and Materials You'll Need
Before you begin, gather the necessary tools and materials:
- Geissele G2S Trigger: Obviously! Ensure you have the correct model for your specific firearm.
- Punch Set: A good quality punch set including a roll pin punch is crucial. Sizes will vary depending on your firearm, so check your firearm's manual.
- Hammer: A small hammer will provide sufficient force for driving out and installing pins. Avoid using excessive force.
- Screw Driver: You'll likely need a small flathead screwdriver. Again, check your firearm's manual for specifications.
- Clean Workspace: A clean, well-lit workspace is essential for precision work.
- Firearm's Manual: This is crucial for specific instructions relating to your firearm.
Step-by-Step Installation Guide
This guide provides a general overview. Specific steps may vary slightly depending on the make and model of your firearm. Always refer to your firearm's manual for precise instructions.
1. Safety First!
- Unloaded Weapon: Before you even think about touching your firearm, verify that it is completely unloaded. Visually inspect the chamber and magazine well.
- Safe Environment: Work in a safe, controlled environment where no one can accidentally interrupt the process.
2. Disassembly
- Remove Upper Receiver: Carefully remove the upper receiver from the lower receiver.
- Identify Components: Locate the existing trigger components. Familiarize yourself with their placement before attempting to remove them.
3. Trigger Pin Removal
- Locate Trigger Pins: Identify the trigger pins holding the trigger group in place. These pins are usually located at the front and rear of the trigger assembly.
- Punching Out Pins: Using the appropriate sized roll pin punch, carefully punch out the trigger pins. Tap gently, applying consistent pressure until the pins are fully removed. Avoid damaging the surrounding components.
4. Removing the Old Trigger
- Careful Removal: Once the pins are removed, gently remove the existing trigger group. Take note of the orientation and arrangement of parts. This will help during reassembly.
5. Installing the Geissele G2S Trigger
- Alignment: Carefully align the Geissele G2S trigger group with the receiver's trigger housing. Ensure everything is correctly seated.
- Insert Pins: Using the punches, carefully insert the trigger pins back into their respective holes. Gently tap them into place using the hammer, again avoiding excessive force. Ensure the pins are flush.
6. Reassembly
- Reattach Upper Receiver: Carefully reattach the upper receiver to the lower receiver.
- Function Check: Before firing, always perform a function check to ensure the trigger operates correctly. Dry fire the weapon (without ammunition) to test the trigger pull and reset.
Troubleshooting Common Issues
- Pin Binding: If you encounter difficulty inserting pins, ensure everything is correctly aligned.
- Trigger Issues: If the trigger doesn't function correctly, double check the installation and refer to the Geissele and your firearm's manuals.
Conclusion
Installing a Geissele G2S trigger can significantly enhance your firearm's performance. By following these steps and prioritizing safety, you can enjoy the benefits of this upgrade. Remember, if you are unsure about any step, consult a qualified gunsmith. This guide serves as an informative resource and should not replace professional guidance. Always handle firearms responsibly and safely.
